Details
Cuboid Mini kit with the new NotchCoilTM 0.25ohm DL. head brings you great vaping experience ever. It lasts longer and can be used under high wattage condition. With the special oblong shape the Cuboid Mini Atomizer can perfectly match the device. The Cuboid Mini applies two sets of battery protection circuit system which makes it more advanced and reliable. Carrying Variable Temperature Control system, built-in battery and multiple attractive colors, it is more practical and attractive catering to your preference. Also, upgradable firmware always enables it up-to-date.
The Cuboid Mini comes with the similar design of the Cuboid but in a tiny shape, which is much easier to grip It is powered by a 2400mAh built-in battery, whose maximum output can be reached to 80W.
Cuboid Mini applies two sets of battery protection circuit system, realizing overall battery protection of
over-charging, over-current and over-discharging, which makes it more safe and reliable.
We kindly recommend the new NotchCoilTM 0.25ohm DL. (Direct Lung) head which lasts longer and can be used under high
wattage condition. It will surely bring you great vaping experience ever.
This TFTA-Tank (top filling and top airflow tank) allows the top section and coil to be removed and as one solid unit.
Coil replacement and juice fill can be achieved by removing this top section from the cup.
Cuboid Mini comes with the upgradeable firmware.
Having Version 3.00 for Cuboid Mini, Temp-SS316 and customized TCR are available.
NotchCoil TM 0.25ohm DL . head, BF SS316 Series Heads, BF Clapton-1.5ohm head, BF Ni, BF Ti and BF RBA head.
In power-off condition, press the fire button and the right regulator simultaneously for around 5 seconds,
then you enter into the TCR set menu:
And here's the TCR Value Range for your reference:
Applied with 510 stainless steel thread and wide border fitting for large capacity atomizers.
The ventilation holes are placed on the bottom which can greatly help the device for better heat dissipation.
Note: Should you get stuck while upgrading, just press the "+" button and then insert into the reset hole with a needle to restart.
