Cuboid, applies Variable Temperature Control system with firmware V3.0 and 150W output, having Temp-SS316 and customized TCR available now.
It is powered by two replaceable 18650 cells with the new slip-open cover.
Multiple colors, 0.96-inch OLED screen and the new dual-battery bar display make it more practical and attractive catering to your preference.
Upgradeable firmware enables it always up-to-date. Now you can upgrade your Cuboid to 200W via VT Software.
Cuboid uses two replaceable batteries with the new dual battery bar.
The maximum output can be reached to 150W, making it powerful and convenient.
We kindly recommend high-rate 18650 cells with rated discharge current≥25A.
The new slip-open cover on the bottom enables you change your battery swiftly by pulling the slider over.
With the Onboard Reverse Polarity Protection, it will protect the device from damage in the event of reverse battery installation.
Cuboid comes with the upgradeable firmware.
Having Version 3.00 for Cuboid, Temp-SS316 and TCR are available now.
Cuboid can be upgraded via VT Software.
The new firmware V3.10 for Cuboid, making the maximum output up to 200W.
Based on the previous Temp-SS mode, we developed the new Temp-SS316 mode.
We kindly recommend you using Joyetech BF-SS316 atomizer heads (0.5ohm/1.0ohm).
In power-off condition, press the fire button and the right regulator simultaneously for around 5 seconds, then you enter into the TCR set menu:
And here's the TCR Value Range for your reference:
Applied with 510 stainless steel thread and wide border fitting for large capacity atomizers.
We kindly suggest you take out the cells and charge them with a separate charger.
The micro USB port is on the top of the left side. Connect it with a micro USB cable to charge or upgrade your device.